Author Topic: Holster for 4410???  (Read 873 times)

0 Members and 1 Guest are viewing this topic.

Offline Locoweed

  • Trade Count: (0)
  • Member
  • *
  • Posts: 46
Holster for 4410???
« on: August 27, 2006, 08:05:05 AM »
Has anyone found a holster that fits the Taurus model 4410?  The long cylinder and frame make it difficult to fit into any other holsters. 

Offline BNoz01

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 192
Re: Holster for 4410???
« Reply #1 on: August 31, 2006, 05:10:00 PM »
Hey,

I'm considering the purchase of a 4410.  Any advice or opinions formulated yet?

Thanks in advance,

B. Noz.

Offline Locoweed

  • Trade Count: (0)
  • Member
  • *
  • Posts: 46
Re: Holster for 4410???
« Reply #2 on: September 01, 2006, 10:22:37 AM »
BNoz, I've been using my 3" 4410 for snake control and have shot five so far this summer.  It's effective with #8 shot out to about 20 feet max for a one shot kill.  I've shot .45 Colt, 000 Buck, and slugs as well at the range and they all tend to shoot low.  The recoil on the shot shells is in the .38 Spl range but the buck and slugs kick like a hot .357 Mag.   I've seen 6" bbl models for sale but have no feedback on their performance.  I've always felt that a shorter barrel handles shot loads better.  Other than snakes I don't know what the pistol is good for.  As a snake getter I couldn't be happier.   Because of the long frame and cylinder it's hard to find a holster that works but I'm getting ready to try something for a 4" S&W "N" frame revolver. 

Offline BNoz01

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 192
Re: Holster for 4410???
« Reply #3 on: September 03, 2006, 07:57:50 AM »
Thanks for the input.  I've long enjoyed my .410 Contender barrel, but it's a lot to wear when not actually hunting. 

B. Noz.