« previous next »
Pages: [1]   Go Down

Author Topic: Removing the Stock from An A-Bolt  (Read 877 times)

0 Members and 1 Guest are viewing this topic.

Offline mlmathis.308

  • Trade Count: (0)
  • Member
  • *
  • Posts: 44
Removing the Stock from An A-Bolt
« on: August 25, 2006, 11:39:46 AM »
 I purchased a Browning A-Bolt from a friend and want to change the stock, Are there any tips or tricks I need to know.


Thanks for any advise


Mike
Logged
Take care and God Bless

Offline Will_C

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 201
Re: Removing the Stock from An A-Bolt
« Reply #1 on: August 30, 2006, 03:30:54 PM »
If you have ever taken the stock off of a bolt action rifle, you can do the same to an A-bolt.
Will
Logged

Offline mjbgalt

  • Trade Count: (26)
  • Senior Member
  • *****
  • Posts: 2367
  • Gender: Male
Re: Removing the Stock from An A-Bolt
« Reply #2 on: August 30, 2006, 05:25:11 PM »
it will be REALLY on there, so be careful but don't be afraid to TAP the barrel gently with a non-marking rubber mallet or the palm of your hand to snap it loose. A-Bolts are glass bedded and, in mine, the bedding basically glued the barreled action into the stock.

-Matt
Logged
I have it on good authority that the telepromter is writing a stern letter.
Pages: [1]   Go Up
« previous next »