« previous next »
Pages: [1]   Go Down

Author Topic: RamRod Holder  (Read 727 times)

0 Members and 1 Guest are viewing this topic.

Offline Canadian81

  • Trade Count: (1)
  • Member
  • *
  • Posts: 34
RamRod Holder
« on: January 14, 2006, 06:23:43 AM »
How is the front ram rod holder held on to the barrel of the Huntsman? I don't use the stock ram rod and I was wondering if there is anyway to remove it? I was also wondering if a laminated forearm from a rifle would fit on the barrel? Any info would be greatly appritieated.
Logged

Offline Busta

  • GBO Supporter
  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 2586
  • Gender: Male
RamRod Holder
« Reply #1 on: January 14, 2006, 12:19:01 PM »
My 2003 stainless steel Huntsman has a dovetail that the ring is pressed into. Don't know if you can knock it out though. It is possible it would go easier one way ot the other. Take a set a calipers and measure it first, it might be slightly wedge shaped. You might want a filler for the dovetail if you remove it though.

Yes the laminated forarm will fit the Huntsman.
Logged
U.S.A.F. Veteran
NRA Life Member

Offline mangulator

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 477
RamRod Holder
« Reply #2 on: January 14, 2006, 01:32:13 PM »
Mine is the same as Busta's but it's a blued model... Picked it up in 2003...
Logged

Offline tscott

  • Trade Count: (1)
  • A Real Regular
  • ****
  • Posts: 561
RamRod Holder
« Reply #3 on: January 14, 2006, 02:24:24 PM »
Tap it out with a hammer and screwdriver. Put a good pack rod in your backpack. After I took a rasp to the Handi forearm to streamline, I much prefer the handling of my Huntsman now. I hate the ramrod, and the plug.
However, I love the accuracy... So I only shoot it at deer!
Logged
Pages: [1]   Go Up
« previous next »