Author Topic: Aluminum bronze? (Read 857 times)

maddmaxx · « **on:** May 15, 2004, 08:18:12 AM »

I might have asked someplace, but I don't remember where, so... Is aluminum bronze good for a bbl? Or just for bearings? Have a piece 2.5" and would like to build a blunderbuss, but not a grenade! If the metal fails, will it rip or shatter? Can a reliable test piece be made to give a fair estimation? And if so, how? Since I can't be sure how it will be loaded a in a generation or two, I'd rather error on the safe side. Estimated bore: 1"- 1.5" at breach and tapered to muzzle. Lot of work carving chips, so if it's a bad idea, maybe I'll try to trade for a piece of better stuff; hopefully DOM bronze. Comments wanted. MM

Double D · « **Reply #1 on:** May 15, 2004, 08:38:08 AM »

works just fine for the decorative outside as long as you put a steel liner in it.

maddmaxx · « **Reply #2 on:** May 17, 2004, 01:31:47 PM »

OK. So it would be easier to make it from steel then have it plated. Will hot-roll be good enough, or should I figure on something better? Another Question: Where do I look for information on blunderbusses?

Double D · « **Reply #3 on:** May 18, 2004, 01:04:42 AM »

No , If you feel you need a bronze gun make the tube from bronze and pit a liner in it.

We have two threads here on the board you should check out.

First the thread on the The More Complete Cannoneer If you are going to build your own gun and shoot cannons you need this book.

Next look at Whar iz everybody?
The story of Calmity Janes Cannon!!