« previous next »
Pages: [1]   Go Down

Author Topic: Marlin/Glenfield feeding problem  (Read 560 times)

0 Members and 1 Guest are viewing this topic.

Offline dahelm

  • Trade Count: (0)
  • Member
  • *
  • Posts: 7
Marlin/Glenfield feeding problem
« on: January 21, 2013, 07:05:58 AM »
I just bought an old Marlin/Glenfield Model 75. After a good cleaning I remedied most of the feeding problems except one. It always fails to feed the last round in the tube. It stays low and it take some doing to get it loose. I suspect it might be the feeding tube but I really don't know. I can't find another to purchase to try out.  Any advice?
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Marlin/Glenfield feeding problem
« Reply #1 on: January 28, 2013, 06:51:59 PM »
Sounds like a new tube mag spring is needed.. Try Brownells.. They may not have a complete assembly but springs available.. GunPartsCorp should be able to help with a complete inner tube..
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline dahelm

  • Trade Count: (0)
  • Member
  • *
  • Posts: 7
Re: Marlin/Glenfield feeding problem
« Reply #2 on: January 29, 2013, 05:14:43 AM »
Thanks gunnut69!!!  I think I'll give that a try.
Logged
Pages: [1]   Go Up
« previous next »