« previous next »
Pages: [1]   Go Down

Author Topic: Marlin levers...  (Read 761 times)

0 Members and 1 Guest are viewing this topic.

Offline evidrine

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 247
  • Gender: Male
Marlin levers...
« on: October 01, 2012, 11:47:51 AM »
I have a quick question. I have a spare Leupold scope base for a Marlin 336R. My cousin is asking me if he could use it on his Marlin .444 lever (Not sure the model) since I dont need it. My question is about if it will fit his .444 as well? I'm not sure if the holes would line up. Is is typically the same rilfe design? Or, is it different and I should just tell him it will not fit?
Logged

Offline Empty Quiver

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2847
Re: Marlin levers...
« Reply #1 on: October 01, 2012, 01:12:54 PM »
A quick check of Brownel's indicates all the Leverguns take the same Weaver base.
Logged
**Concealed Carry...Because when seconds count help is only minutes away**

Offline Winter Hawk

  • Trade Count: (47)
  • Senior Member
  • *****
  • Posts: 1947
  • Gender: Male
Re: Marlin levers...
« Reply #2 on: October 01, 2012, 05:11:08 PM »
It should fit no problem.

-WH-
Logged
"All you need for happiness is a good gun, a good horse and a good wife." - D. Boone
Pages: [1]   Go Up
« previous next »