Ok got some of the rebuild posted on photobucket , here are some

One fork removed

pieces and parts layed out in a row


Top piece of the fixture for installation

Socket with 17 mm hex head for the internal plug assembly

Bottom of leg on jack

Pic of position of leg on homemade fixture

Spring is longer than leg so the jack pushes the socket on the spring till it is short enough to reach the threads

When the leg starts to be forced down all you gotta do is pull it into the threads and turn it by hand
This is a much easier method than standing on the seat and pushing the spring in . This is a progressive rate wound spring designed to support the front of a 900 pound bike The plug is flat where it sits on the spring . Teeth have been lost and it will hurt you if your hand slips. My method though much easier to do is still not without it's possibility of hurting you bad. The sring is under lots of force . Be careful if you try either way.