« previous next »
Pages: [1]   Go Down

Author Topic: Barrel fitting, please confirm my thinking  (Read 616 times)

0 Members and 1 Guest are viewing this topic.

Offline Rangeball

  • Trade Count: (1)
  • Member
  • *
  • Posts: 92
Barrel fitting, please confirm my thinking
« on: February 02, 2010, 06:08:07 AM »
Just received a stub I bought for a project.  .410 barrel that's been cut off and de-milled, going on a 2004 rifle receiver.

Locks up with a nice click.  No visible top gap.  Locks up with aluminum foil.  Latch lever has good movement when locked up both with and without aluminum foil. Will not lock up with a post it note.  No side to side play at all.  I think I'm good to go, but would feel better with your input.

Should I play the lottery today?

:)
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43304
  • Gender: Male
Re: Barrel fitting, please confirm my thinking
« Reply #1 on: February 02, 2010, 06:13:45 AM »
Sounds like a great start.  ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline Rangeball

  • Trade Count: (1)
  • Member
  • *
  • Posts: 92
Re: Barrel fitting, please confirm my thinking
« Reply #2 on: February 02, 2010, 06:22:54 AM »
Sweet...  ;D
Logged

Offline Old Grizz

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 387
  • Gender: Male
Re: Barrel fitting, please confirm my thinking
« Reply #3 on: February 02, 2010, 07:28:12 AM »
Should I play the lottery today?

:)
[/quote]YEP!!!!!!!!! ;D ;D ;D ;D
Logged
Marlin 1895G Rules
45-70
Member Team Hornady
Life Member NRA
Member NAHC

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: Barrel fitting, please confirm my thinking
« Reply #4 on: February 02, 2010, 08:15:08 AM »
It sounds good, but none of that matters until you install the new barrel and finish off the breach end.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline Rangeball

  • Trade Count: (1)
  • Member
  • *
  • Posts: 92
Re: Barrel fitting, please confirm my thinking
« Reply #5 on: February 03, 2010, 03:17:54 AM »
Quote from: trotterlg on February 02, 2010, 08:15:08 AM
It sounds good, but none of that matters until you install the new barrel and finish off the breach end.  Larry

Larry, what's likely to change?  This is for a smokeless muzzle loader if that makes a difference. Breech face of stub will be left as is.
Logged
Pages: [1]   Go Up
« previous next »