« previous next »
Pages: [1]   Go Down

Author Topic: BC Scope Ring Height  (Read 208 times)

0 Members and 1 Guest are viewing this topic.

Offline rfcjr

  • Trade Count: (0)
  • Posts: 1
BC Scope Ring Height
« on: January 28, 2009, 08:15:18 AM »
I am considering putting an older K-4 scope on a new H&R Buffalo Classic 45-70. For an inexpensive setup I am thinking about using the Leupold base and either Tasco or Barska rings. Can anybody advise me as to what height ring set I should get to adequately clear the hammer? Thank you.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43304
  • Gender: Male
Re: BC Scope Ring Height
« Reply #1 on: January 28, 2009, 08:23:55 AM »
Welcome! Scope rings and height are covered in the FAQs and Help sticky in the brown section at the top of this forum, do yourself a favor and spend some time reading there, you'll find answers to questions you don't even know you have yet!!  ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »