« previous next »
Pages: [1]   Go Down

Author Topic: Got a Question here  (Read 437 times)

0 Members and 1 Guest are viewing this topic.

Offline Greeenriver

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 231
Got a Question here
« on: December 11, 2008, 02:12:30 PM »
I was just wondering who would be the one to contact to have a couple new cylinders fitted and chambered for my pair of new Colts SAA's??  They are in .45 Colt caliber and I would like to have cylinders chambered for the .45 Cowboy Special cartridge fitted to them.  I know that the .45 CS can be shot in regular .45 Colt chambers, but would like the extras chambered for them specificly.

Would Allan Harton be the one, or best, or someone else?

Any advice would be welcome to me.

The pistols are a special run from the Custom Shop with all blued black powder frames and 4%3/4 in barrels, with the bullseye ejactors. They will be going to Paul Persenger after the first of the year, (I hope, that's the plan now), for real Ivorie grips.

And then, they will be my main match revolvers for Cowboy Action Shooting and hopefuly get the snott shot out of them!!!!!

Greeenriver
Logged
Most of life's problems can be handled by a sutiable application of high explosives

Offline Bigeasy

  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 1986
  • Gender: Male
Re: Got a Question here
« Reply #1 on: December 11, 2008, 10:04:39 PM »
Greenriver-  Will the Colt Custom shop do it?  Maybe USFA might.  Those are just two off the top of my head.

Larry
Logged
Personal opinion is a good thing, and everyone is entitled to one.  The hard part is separating informed opinion from someone who is just blowing hot air....
Pages: [1]   Go Up
« previous next »