« previous next »
Pages: [1]   Go Down

Author Topic: help!!!!!!!!!  (Read 642 times)

0 Members and 1 Guest are viewing this topic.

Offline badshotlal

  • Trade Count: (0)
  • Member
  • *
  • Posts: 56
  • Gender: Male
help!!!!!!!!!
« on: October 27, 2008, 11:02:45 AM »
Good day,

  I have a Savage 110, new, that I've been painting for a predator rifle.
  After cleaning the bore, I've discovered the safety will not disengage the trigger.
  Now it's important to understand I need instructions for a hammer.  Twisted off six Craftsman screwdriver sets until someone told me I was going the wrong way -- story of my life!
  Sooooooo, I can see the safety engaged in the notch in the trigger, but will not move after the action is cocked.  Can you help?
  Hope you have a good evening.

God Bless

badshotlal   :-[
 

 ;D
Logged

Offline Dave in WV

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2162
Re: help!!!!!!!!!
« Reply #1 on: October 27, 2008, 12:02:50 PM »
Bolt handle turned all the way down?
Logged
Setting an example is not the main means of influencing others; it is the only means
--Albert Einstein

Offline badshotlal

  • Trade Count: (0)
  • Member
  • *
  • Posts: 56
  • Gender: Male
Re: help!!!!!!!!!
« Reply #2 on: October 27, 2008, 12:58:57 PM »
Hi Dave,
  Thanks for the reply.  Yes, it's down completely.  I can see where the safety is enganged  to the trigger, but darned if I can see how it disengages!!! ::)
  Sure appreceiate any comments or thoughts.

God Bless

badshotlal
Logged

Offline badshotlal

  • Trade Count: (0)
  • Member
  • *
  • Posts: 56
  • Gender: Male
Re: help!!!!!!!!!
« Reply #3 on: October 27, 2008, 01:41:00 PM »
Well,

  Guess it helps to read the instructions.  Still don't know what the lever is for, but can not believe I've got so old I just didn't see the safety on the tang.
  Yea, that's dumb!!  Sorry for taking up your time.  Now, if I can just find a bigger hammer!!!

God Bless

badshotlal ???

Logged

Offline Nobade

  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 1927
Re: help!!!!!!!!!
« Reply #4 on: October 28, 2008, 02:05:39 AM »
The lever on the side is the sear. You pull the trigger and push it forward at the same time to remove the bolt. BTW, the safety won't work if the gun's not cocked.
Logged
"Give me a lever long enough, and a place to stand, and I'll break the lever."

Offline Dave in WV

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2162
Re: help!!!!!!!!!
« Reply #5 on: October 28, 2008, 12:12:25 PM »
I had to read and reread your post after mine to understand what was going on. I could not figure out why the safety wouldn't disengage as it is a simple trigger assembly. No harm. Safe hunting and shooting, Dave
Logged
Setting an example is not the main means of influencing others; it is the only means
--Albert Einstein
Pages: [1]   Go Up
« previous next »