Author Topic: VVC barrel ? (Read 575 times)

PJ · « **on:** May 11, 2003, 08:31:18 PM »

I would like to know if you can use factory forends on their barrels or do you have to use their forend hanger bar system?

KYODE · « **Reply #1 on:** May 12, 2003, 01:51:31 AM »

you can order it any way you want pj. my 13"6br uses the factory forend. you can also order it with a hanger bar setup. you can also specify if you want the standard spacing for 14" barrel forends, or wider spacing for carbine forends.

SD Handgunner · « **Reply #2 on:** May 12, 2003, 03:54:39 AM »

YEP you can get their barrels about anyway you want them. When I ordered my 15" Stainless-Steel 6mm T/CU from VVCG's, Steve and I discussed Rifling Twists, Forend Dovetail Spacing, Throat Dimensions and a lot of other options. In the end I ordered my 15" Barrel with the Forend Dovetail Spacing for the Super 16 / Carbine Forends. Once the Barrel arrived I just opened up the barrel channel to free float the forend, and I was good to go.

Larry

helobill · « **Reply #3 on:** May 12, 2003, 05:25:25 PM »

They use normal TC super 14 spacing on the dovetails as standard for their pistol barrels but can do anything you want. their hanger bar system mounts to normal super 14 spacing. But you can only use their forends with thier hanger (or drill an extra hole and let out the forend so the hanger will fit in it) Turn their hanger around and it's the same setup as the pachmyer hanger bar, and will accept pach forends. I like their hanger and forends, just put the finish on a target forend. Very nice!
Helicopter Bill

PJ · « **Reply #4 on:** May 12, 2003, 05:32:27 PM »

Thank's