« previous next »
Pages: [1]   Go Down

Author Topic: New Barrel tool from the Factory  (Read 697 times)

0 Members and 1 Guest are viewing this topic.

Offline dougk

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1937
  • Driftwood TEXAS
New Barrel tool from the Factory
« on: December 22, 2006, 11:30:47 PM »
I just received the barrel tool from the factory.  I was expecting the disk that they show on the web page.  But I ended up with a metal version of the old tool, the only difference was that the allen wrenches where not integrated in to the cross bar.  I was very pleased with this latest version.  And it was cheaper than the going ebay rate.

Doug
Logged

Offline RollTide

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 457
Re: New Barrel tool from the Factory
« Reply #1 on: December 23, 2006, 12:27:18 AM »
Thanks for the info Doug.  Do you mind sharing how much the tool cost from the factory?

Roll Tide

Logged

Offline dougk

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1937
  • Driftwood TEXAS
Re: New Barrel tool from the Factory
« Reply #2 on: December 23, 2006, 03:26:35 AM »
It was $32 plus $3 for shipping.  I like it much better than the plastic tool.
Logged
Pages: [1]   Go Up
« previous next »