« previous next »
Pages: [1]   Go Down

Author Topic: 30-30 loads for the handi  (Read 746 times)

0 Members and 2 Guests are viewing this topic.

Offline bub524

  • Trade Count: (23)
  • Contributor
  • ***
  • Posts: 366
30-30 loads for the handi
« on: November 04, 2006, 02:27:38 PM »
Can anybody share their favorite 30-30 loads that do well in the handi?
Logged
"Outside of a dog, a book is mans best friend. Inside of a dog, it's too dark to read." G. Marx

Offline canon6

  • GBO Supporter
  • Trade Count: (119)
  • Senior Member
  • *****
  • Posts: 1508
  • Gender: Male
Re: 30-30 loads for the handi
« Reply #1 on: November 04, 2006, 02:56:56 PM »
I am using a 125Gr Nosler Ballistic Tip,at aroung 2750  it is very accurate and shoots really flat.I am using RL7  and am not showing any pressure signs,check Lee second edition for pressure guidlines   HTH  Doug
Logged
a armed man is his own master

Offline andrewtheelder38

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 125
Re: 30-30 loads for the handi
« Reply #2 on: November 05, 2006, 04:10:40 AM »
....if it helps, I am shooting the elcheapo remington corelokt 150-grain bullets which i bought in bulk very inexpensively from midwaysa and loading 38.0 grains of Hodgdon H380....decent power good accuracy and very low pressure....but the highest velocities are obtained with H4895...34 grains will give you 2409 with a 150 bullet....but i haven't tried that since i do not own any of that powder......
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43309
  • Gender: Male
Re: 30-30 loads for the handi
« Reply #3 on: November 05, 2006, 04:57:12 AM »
Quote from: andrewtheelder38 on November 05, 2006, 04:10:40 AM
....but the highest velocities are obtained with H4895...34 grains will give you 2409 with a 150 bullet....but i haven't tried that since i do not own any of that powder......

I wouldn't try it without working up to it, that's a max load according to Hodgdon.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline MSP Ret

  • GBO Supporter
  • Trade Count: (173)
  • Senior Member
  • *****
  • Posts: 8940
  • Gender: Male
Re: 30-30 loads for the handi
« Reply #4 on: November 05, 2006, 06:04:56 AM »
I just finished loading up some Hornady 150 grain RN and some 140 grain Barnes X-bullets (spitzer bt's) each ahead of 30 grains of 3031 in Winchester brass. I have not shot them yet but hope for good results, especially with the Barnes bullets. 28.5 grains of 3031 behind a 150 grain jacketed RN is reported to be an accurate load for the 30-30....<><.... :)
Logged
"Giving up your gun to someone else on demand is called surrender. It means that you have given up your ability to protect yourself to a power that is greater than you." - David Yeagley

Offline PeterCartwright

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 289
Re: 30-30 loads for the handi
« Reply #5 on: November 05, 2006, 01:15:29 PM »
For what it's worth, my handi will put three plain, Jane 150 gr. Rem. CoreLokts (factory loads) into about an inch@100 yards.  I haven't even tried to better that with handloads.
Logged
Pages: [1]   Go Up
« previous next »