« previous next »
Pages: [1]   Go Down

Author Topic: Gap between barrel end and receiver question....  (Read 458 times)

0 Members and 1 Guest are viewing this topic.

Offline coyotehunter223

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 120
  • Gender: Male
Gap between barrel end and receiver question....
« on: January 29, 2012, 10:03:52 AM »
Hi, I have a 12ga. Pardner that I bought used. It needed a transfer bar which I bought from Numerichs and installed that with nor problems. I didn't notice at first but if I hold the gun up to a light I can see a little space where the barrel meets the receiver. I measured the space with quality guages and it is between .003 and .0035 inches. Is this safe? The gun does appear to lock up ok with no movement.  Thanks
Logged

Offline Lon371

  • GBO Supporter
  • Trade Count: (53)
  • Senior Member
  • *****
  • Posts: 2486
  • Gender: Male
  • Why Not a Handi?
Re: Gap between barrel end and receiver question....
« Reply #1 on: January 29, 2012, 08:45:35 PM »
 probably ok, but I would try a .003 maybe .oo2 shim on the hinge pin and see if it tightens it up a hair more.
 
Lonny
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43304
  • Gender: Male
Re: Gap between barrel end and receiver question....
« Reply #2 on: January 30, 2012, 06:12:21 AM »
Scattergun barrels aren't as critical and a rifle barrel for fit, as long as the barrel is tight with the forend removed, shoots and ejects fine, I wouldn't worry about it, it's probably just the barrel face that isn't true.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline coyotehunter223

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 120
  • Gender: Male
Re: Gap between barrel end and receiver question....
« Reply #3 on: January 30, 2012, 12:10:12 PM »
Thank you both very much!
Logged
Pages: [1]   Go Up
« previous next »