Author Topic: Can you use 7mmBR brass to make 6mmBR brass ? (Read 1074 times)

PJ · « **on:** December 24, 2002, 04:22:06 PM »

I was just looking at the two and the 7mmBR uses Large rifle primers and the 6mmBR uses Small rifle primers.Can you just run the 7mmBr case in the 6mmBR die ?

Jay HHI6818 · « **Reply #1 on:** December 24, 2002, 05:31:43 PM »

Hi PJ,
I have both and they both use a "SMALL" rifle primer. As far as necking the 7BR down to 6BR depends on the 6BR neck diameter. I'll bet it probablt won't chamber. Why not but Lapua 6BR brass?

KYODE · « **Reply #2 on:** December 24, 2002, 06:05:33 PM »

why would you want to? if you can buy the 6br brass ready to go. lapua brass is highly recommended by everyone i ever talked to. it's not much more expensive at www.midwayusa.com . i believe the reason for the small rifle primer was to enhance accuracy in the short fat case. the 6ppc is where they learned this, i think. the small rifle primer will be no disadvantage. :grin: [/url]

PJ · « **Reply #3 on:** December 24, 2002, 06:46:22 PM »

Thank's for the info. the book must have a typo because, it said it used Large rifle primers in the 7mmBR.