« previous next »
Pages: [1]   Go Down

Author Topic: Refinish a lam w/ H&R medallion?  (Read 350 times)

0 Members and 1 Guest are viewing this topic.

Offline eskimo36

  • Trade Count: (156)
  • Senior Member
  • *****
  • Posts: 1359
  • Gender: Male
    • Adventure Rider
Refinish a lam w/ H&R medallion?
« on: July 07, 2007, 11:10:22 AM »
How is the medallion attached on a set of factory lams?  I was going to thin a set down, refinish it, and i really don't care for the shiny medallion. any help? Thanks guys.
Logged
"one shot is usually enough"

Offline oneshotonekill

  • Trade Count: (15)
  • A Real Regular
  • ****
  • Posts: 503
Re: Refinish a lam w/ H&R medallion?
« Reply #1 on: July 07, 2007, 02:00:19 PM »
It looks like they just inlet the stock for the medallion then glue or epoxy it in.
Logged

Offline DalesCarpentry

  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 6111
  • Gender: Male
  • I would rather be shooting!!
Re: Refinish a lam w/ H&R medallion?
« Reply #2 on: July 07, 2007, 04:16:10 PM »
If you don't want it and you end up removing it without damage. I would like to have it. I could route a hole in my stock for it.   thanks Dale
Logged
The quality of a mans life is in direct proportion to his commitment to excellence.

A bad day at the range is better than a good day at work!!
Pages: [1]   Go Up
« previous next »