« previous next »
Pages: [1]   Go Down

Author Topic: McMillan A2 torque specs.  (Read 543 times)

0 Members and 1 Guest are viewing this topic.

Offline SR25MK4

  • Trade Count: (0)
  • Posts: 2
    • http://www.geocities.com/sr25mk4
McMillan A2 torque specs.
« on: April 16, 2003, 05:59:21 PM »
Hello:

I need to know the proper specs in inch pounds for the action screws on a Remington 700 and Savage 10FP when torquing a McMillan A2 Tactical stock in place. The stock is not glassed or pillar bedded. Also, if there is a proper sequence for the front and rear screws.


Thank you,
Logged
Patrick Cimo
National Rifle Association Endowment Member
Police Marksman Association Original Life Member

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
McMillan A2 torque specs.
« Reply #1 on: April 17, 2003, 03:20:21 AM »
I would contact McMillan for their input..  I usually don't bother torgueing action screws.  I just put the front scerw down first the rear screw last just snug and if there should be a middle screwjust make it barely finger tight.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."
Pages: [1]   Go Up
« previous next »