Well I have scoped my Encore, but I still want to put the factory rear sight on as back-ups in case. The only problem is one of the screws that adjusts the elevation plate is all buggered up. I was using a proper sized screw driver, but the screw head almost "melted" as I turned it. The other side is fine, but this one is messed up. The messed up screw had just barely been touching the bell of my scope, so I took it off. Im figuring if I put a new screw on there I might be able to get the site back on there nice and not touching. So this leads me to my question, what is the thread size for these screws? I could probably guess by looking around at what they have at the Hardware store, but would save me a little time. Thanks in advance.
Brian M.
