« previous next »
Pages: [1]   Go Down

Author Topic: Installing sights on a 23" Contender factory barrel  (Read 433 times)

0 Members and 1 Guest are viewing this topic.

Offline teamnelson

  • Trade Count: (30)
  • Senior Member
  • *****
  • Posts: 4495
  • Gender: Male
Installing sights on a 23" Contender factory barrel
« on: April 02, 2013, 11:09:58 AM »
Folks,


Seems the only barrels available these days are the 23" .810 variants, which were not d/t for sights. Has anyone installed sights on theirs? Did you DIY, in which case could you describe what you did? If not, is there a 'smith you recommend? Thanks!


S/F, Chaps
Logged
held fast

Offline Mike Scott

  • Trade Count: (3)
  • Avid Poster
  • **
  • Posts: 137
Re: Installing sights on a 23" Contender factory barrel
« Reply #1 on: April 05, 2013, 03:52:11 AM »
You can buy a drill/tap/jig kit from MidwayUSA and do it yourself or any decent gunsmith or machinist should be able to do it
Logged
Pages: [1]   Go Up
« previous next »