« previous next »
Pages: [1]   Go Down

Author Topic: bore polishing  (Read 432 times)

0 Members and 1 Guest are viewing this topic.

Offline cbourbeau32

  • GBO Supporter
  • Trade Count: (44)
  • A Real Regular
  • *****
  • Posts: 801
  • Gender: Male
bore polishing
« on: January 28, 2007, 04:39:59 PM »
I ordered some Wheeler Engineering lapping compound from MidwayUSA and finally got around to using it today on my 243 and 7mm08 handi's. I only used the 2 less abrasive grits (320 and 600) for 50 strokes each like the bore preperation instructions state. When I started I could hardly get a certain size patch down the bore, but when I was finished the bore looked like a mirror between the groves and the same size patch went down almost effortlessly. I can't wait to get out to the range and try some handloads I am working up for both calibers I will share a range report as soon as I get out to shoot. Charlie
Logged
NRA Life Member, US Navy Veteran.

Oklahoma has 77 counties, Romney-77, Obama-0

I'll keep my Guns, my Freedom's and my Money.
You can keep the "Change"

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43304
  • Gender: Male
Re: bore polishing
« Reply #1 on: January 29, 2007, 06:57:40 AM »
I hope that works for ya Charlie, also hope it wasn't too agressive for the shallow rifling. We'll be looking forward to your range report.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »