« previous next »
Pages: [1]   Go Down

Author Topic: encore trigger improvement  (Read 805 times)

0 Members and 1 Guest are viewing this topic.

Offline tpic402

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
encore trigger improvement
« on: June 28, 2010, 04:29:23 PM »
What is the best way to improve trigger pull on a new encore rifle frame,some companies offer spring kits,some others will do for you,  What have you done, antoher question is a stronger hammer spring needed when using a aluminum spur I have had several missfires with remington brass, primer pocket does seem a bit deep though. Thanks Tom
Logged

Offline DubTee

  • Trade Count: (0)
  • Member
  • *
  • Posts: 7
Re: encore trigger improvement
« Reply #1 on: June 29, 2010, 07:52:39 AM »
I sent mine to SHOTS gunsmithing in Oregon, Jim did a great job.  Factory pull was 5.9 lbs, he installed the over travel screw and got it pulling 2.8 lbs as requested, very clean and crisp.  Very reasonable pricing and a great turn around time.
Logged

Offline wallygater

  • Trade Count: (0)
  • Member
  • *
  • Posts: 8
Re: encore trigger improvement
« Reply #2 on: June 30, 2010, 02:59:50 AM »
I have also sent two encores to Jim best thing I ever did for an Encore. Jim is great, very good work, great turn around time and very knowledgable if you have questions about anything TC.


Wally
Logged

Offline tpic402

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
Re: encore trigger improvement
« Reply #3 on: June 30, 2010, 04:29:20 PM »
Could you give me a contact or e-mail if you have handy. Thanks
Logged

Offline tpic402

  • Trade Count: (0)
  • Member
  • *
  • Posts: 75
Re: encore trigger improvement
« Reply #4 on: June 30, 2010, 04:30:49 PM »
Never mind found it just getting lazy I guess  Thank you for replying Tom
Logged
Pages: [1]   Go Up
« previous next »