stiff G2 trigger

[SAS98M]

Is there any easy/inexpensive way to spuce up the trigger on a G2-mine breaks at roughly 6.5 # would like to get it down to about 3.25 # without any major ordeals ? Any input would be appreciated. Shane

[Dezynco]

There is that little "spring" trick that you can do, but with any advice you get on the net, you take matters into your own hands.  I see no real problem with this so I'll pass along the information.....but you didn't hear me type it....

Take the screw out that holds in the trigger guard assembly, then push out the pin that holds the trigger into the frame.  There is an "L" shaped spring that rides in the little hole in the front of the trigger.  Take a small flat-blade screwdriver and give the "L" shaped spring a good push towards the front/top of the frame.  This will take a little of the tension out of the spring.

Re-assemble and test, if it still feels a little stiff, repeat.  I wouldn't do this more than twice, if you can't reduce the trigger pull with two stretches, don't overdo it,  you probably need to send it to the 'smith.

BTW.  While you've got it apart, you might consider putting a drop of Lucas Gun Oil on the sear and hammer surfaces.  That stuff is slicker that snot on a doorknob!

[Bullseye]

Can also install a Trapper Spring Kit available from Natchez Shooting Supplies for about $15.

[HAMMERHEAD]

I installed an aftermarket trigger spring and polished the internals. Not the sear notch or mating surface of the hammer, I'm not qualified for that, just the areas of the trigger and sear that push on each other.
As far as the springs go, you'll have to google for them. There are also instructional videos.