Hello Gentlemen! I'm new to this forum, and a new BC owner. I bought a new BC in 45-70 last month and just got to shoot it 2 weeks ago. I put a Williams FP sight on before I shot it to sight it in. I shoot highpower rifle competition and like easily adjustable rear sights. To make a long story short, to get the shots centered on target, I had to set the FP all the way left, and even had to drift the front sight some to the right! Knowing something wasn't right, I put the factory rear sight back on, sat the rifle on a flat surface sitting upright (hammer pointing up at 12 o'clock) and immediately noticed that the rear sight was sitting about 3/16 of an inch to the right of the top center line of the barrel! The rear sight base screw holes had been drilled and tapped off center. A call to customer service got me a prepaid UPS shipping label back to the factory for correction or a new barrel, I hope.
Has anybody else seen this happen on any of your rifles or heard of it? Just curious.