« previous next »
Pages: [1]   Go Down

Author Topic: loose rear sight  (Read 489 times)

0 Members and 1 Guest are viewing this topic.

Offline mb4859

  • Trade Count: (1)
  • Member
  • *
  • Posts: 65
  • Gender: Male
  • First Blood
loose rear sight
« on: October 07, 2009, 02:59:41 PM »
After shooting my new G2 with 410 vent rib barrel I noticed my rear sight was loose.  How do I tighten it?
Logged
Politics is supposed to be the second oldest profession. I have come to realize that it bears a very close resemblance to the first.
- Ronald Reagan

Offline ctrout

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 146
Re: loose rear sight
« Reply #1 on: October 09, 2009, 04:43:00 PM »
remove the elevation screw to reveal the two screws that attach the sight to the barrel.
Logged

Offline mb4859

  • Trade Count: (1)
  • Member
  • *
  • Posts: 65
  • Gender: Male
  • First Blood
Re: loose rear sight
« Reply #2 on: October 10, 2009, 01:59:36 AM »
ctrout, it is a vented rib barrel and the rear sight is a dovetail groove.  The groove is so loose the rear sight will fall out.  I don't know if I'm should dink it to make it tight or glue it in.  I can grab it with my hand and completely remove it because it is so loose. 
Logged
Politics is supposed to be the second oldest profession. I have come to realize that it bears a very close resemblance to the first.
- Ronald Reagan

Offline Keith L

  • Moderator
  • Trade Count: (4)
  • Senior Member
  • *****
  • Posts: 3781
Re: loose rear sight
« Reply #3 on: October 10, 2009, 07:14:25 AM »
I always heard you use a prick punch to raise some metal on the bottom of the dovetail then carefully put the sight in.  I have never done it, so that is all I know.
Logged
"Beer is proof that God loves us and wants us to be happy."  Benjamin Franklin
Pages: [1]   Go Up
« previous next »