Author Topic: RWS "C" Mount problem  (Read 677 times)

0 Members and 1 Guest are viewing this topic.

Offline urika20

  • Trade Count: (0)
  • Member
  • *
  • Posts: 46
RWS "C" Mount problem
« on: August 09, 2003, 02:28:43 AM »
I have a RWS 36 with the C mount. The problem that is occuring is the scope is rotating either right or left from vertical. No forward or backward movement has been detected. Any thoughts or ideas on stopping this.

Clamp screws are tight along with the other screws on the mount.

TIA

urika20

Offline mp-44

  • Trade Count: (0)
  • Member
  • *
  • Posts: 15
RWS "C" Mount problem
« Reply #1 on: August 09, 2003, 09:39:48 AM »
Rough up the inside of the rings with some sandpaper , apply some 3M trim adhesive or contact cement , install scope, tighten then let it set overnight. HTH

Offline Lawdog

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4464
RWS "C" Mount problem
« Reply #2 on: August 09, 2003, 11:41:14 AM »
urika20,

I had this happen years ago with a set of Weaver rings on a .300 Savage.  I took two pieces of inner tube, put one on the bottom of the ring and the other on the top of the scope.  Did this to both rings and cured the problem.  Lawdog
Gary aka Lawdog is now deceased. He passed away on Jan. 12, 2006. RIP Lawdog. We miss you.

Offline urika20

  • Trade Count: (0)
  • Member
  • *
  • Posts: 46
RWS "C" Mount problem
« Reply #3 on: August 09, 2003, 11:56:21 AM »
Thanks guys for your solutions. I had thought about the sand paper but never gave a thought to the cement or adhesive. I do have a bicycle repair kit with the small patches that I'll try first. If it does'nt work than I'll glue it down.

urka20