« previous next »
Pages: [1]   Go Down

Author Topic: Want to personalize my 45-70  (Read 410 times)

0 Members and 1 Guest are viewing this topic.

Offline blackpowderbill

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 287
  • Gender: Male
Want to personalize my 45-70
« on: November 24, 2007, 03:55:00 AM »
I am looking to doll up my 45-70 Handi. Right now its all "as issued except for the old Weaver K1 scope. I an debating on ordering the Williams FP rear sight from H&R. Does any one make a front sight ramp for the Handi that with a dove tail so I can try different front sights?
  Also, what about stocks? The factory stock works ok but has too much wood in it. I would like a thinner stock of walnut or cherry. Due to lack of time, I do not want to make one from a blank. Do you know of some good sources of finished stocks semi complete stocks?
Logged
People are like slinkies, they serve no purpose yet they bring a smile to your face when you push them down the stairs.

Offline 321

  • Trade Count: (0)
  • Member
  • *
  • Posts: 29
Re: Want to personalize my 45-70
« Reply #1 on: November 24, 2007, 04:48:31 AM »
Check the FAQs.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43304
  • Gender: Male
Re: Want to personalize my 45-70
« Reply #2 on: November 24, 2007, 05:33:02 AM »
Bill, see the Peep and Firesights link in the FAQs, Williams makes a shotgun shorty ramp that fits the 45-70 barrel just fine, you can even use it with the small screw that comes on current production barrels, I put one on my new 44mag barrel this week, but it would be best to tap it to 6-48 as cdl mentioned.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »